Advanced 12,000 RPM Spindle with Hybrid Ceramic Bearings
Linear Roller Bearing Slides on All Axes
Coolant Through Spindle (CTS)
and many more...
Specification
Table size
51.18″ x 23.62″
Travel (X, Y, Z axis)
50″ x 27.5″ x 25″
Travel (X, Y, Z axis) with soft limits
50.07″ x 27.70″ x 25.06″
Rapid traverse X, Y, Z
1,000 IPM
Cutting max. speed X, Y, Z
1,000 IPM
T-slots (number x width x pitch)
5 x .709″ x 4.921″
Maximum weight of workpiece
2,200 lbs
Height of table from bottom of floor***
42″
Min. spindle nose to table distance ****
3″
Max. spindle nose to table distance ****
28″
Distance of ATC arm to table
25.75″
Min. machine height ***
106″
Max. machine height (head all the way up) ***
119.25″
Overall width of machine with side doors open and chip conveyor (no chip bin)
202.63″
Overall length of machine with electrical cabinet fully open 180°
156.63″
Footprint of machine with chip conveyor & coolant tank in place. Pendant not rotated 90° (width x length)
168.25″ x 126.50″
Weight net / shipping
15,400 lbs / 15,900 lbs
Spindle Specs
Spindle taper
40 Taper
Spindle speed range
10 - 12,000 RPM
Spindle nose diameter
3.75″
Tool clamping force (90 psi)
2,200 lbs
Tool holder type
CAT 40 standard BT 40 optional (must change ATC arm)
ATC tool capacity
24
Maximum tool weight (incl. holder)
17.6 lbs
Maximum tool diameter
3.07″
ATC arm tool change time
2.5 seconds
Spindle motor HP - peak
67 HP
Spindle motor HP - continuous (480V)
26.8 HP
Spindle center to spindle head casting face
26.75″
Spindle cooler oil capacity
~4.25 gallon
Power Requirements
Power requirements - standard
480V (432-528V is acceptable), 3P, 69A
Power requirements - optional
n/a
Coolant System
Tank capacity
78 gallons
Pressure and volume
8.7 gpm @ 42 psi
Pump and wash power
750 watts
Coolant wash pump
1,290 watts
CTS pump (Coolant Through Spindle)
3 KW / 4 HP
CTS pressure
319 psi
Air Requirements
Air - CFM, SCFM (at 90 PSI)
2.5 CFM, 18 SCFM
Air quality
Air dried/water separator upstream of VMC
Lubrication Requirements
Lubrication pump capacity
2 liters
Lube Oil Type
ISO 32 or 10 W
Specifications subject to change.
** Must remove ATC motors and all sheet metal attached to top of electrical cabinet. The cable way for Z axis also needs to be removed. The lifting point on the electrical cabinet is now the highest point.
*** Height changes slightly based on how machine is leveled on leveling screws.
**** Can vary slightly due to soft limit settings.
.png)
